The Charge Level; Light; Distance Readout; Time Readout - Batavus E-go RemovE Guide D'utilisation

______________________________________________________________________

3.2.5 The charge level

The charge level of the battery is shown by the black blocks on the left side of the
display. The clearest indication of the charge level is displayed if the throttle is not
in use and the assistance level is set to the lowest Eco level.

3.2.6 Light

You can use the 'D' button to turn the light on and off. When the light is turned on,
this is indicated by a symbol at the bottom of the display.
If the battery runs out of power during a trip, the light can still remain on for at least
another two hours.

3.2.7 Distance readout

Repeatedly pressing the 'E' button will make the 'Trip distance' appear at the top of
the display. The distance can be reset by keeping the 'E' button depressed for
three seconds.
Pressing the 'E' button once again will make the 'Total distance' appear. This value
cannot be reset.

3.2.8 Time readout

Repeatedly pressing the 'E' button will make a clock appear at the top of the
display. You can now read the time. The time can be reset by keeping the 'E'
button depressed until the numerals begin to flash. Then use the 'B' and 'C'
buttons to reset the hour. Now press 'E' again and adjust the minutes with the 'B'
and 'C' buttons. Finish by keeping the 'E' button depressed.
By pressing on 'E' again, the 'Trip time' is indicated. You can reset this by keeping
the 'E' button depressed.

3.2.9 Temperature readout

The temperature can be read by pressing repeatedly on the 'E' button until 'temp'
appears at the upper left of the display.

3.2.10 Error messages

®
If a malfunction occurs while using your E-go RemovE system, this will be
indicated by the appearance of the word 'error' at the top of the display.
Your dealer can correct the malfunction.

3.2.11 Adjusting the display's lighting level

The display's lighting level can be adjusted by keeping the 'D' button depressed. Release
pressure on the button when the desired lighting level is reached.
_________________________________________________________________________
11
32