Speedsensor Information; Battery Pack And Charger; Charge The Battery Pack - Batavus Emotion Smart Manuel D'instructions

Sire-e afficheur avec commande au volant

Masquer les pouces Voir aussi pour Emotion Smart:

Les langues disponibles

2.5

Speedsensor information

Your E-bike's system needs information to function properly. The speed

information is obtained by the rear wheel sensor (behind the chain casing)

and a magnet in the wheel. Sometimes the magnet becomes dislodged, for

instance when cleaning the E-bike or when loading/unloading the E-bike on

the bicycle carrier.

If the magnet becomes dislodged, then the speed can no

longer be measured. In this case you can still cycle home safely, or take

your E-bike to the dealer, but only with limited speed and assistance. The

problem can be solved by returning the magnet to the correct position,

see the figure below. If you have returned the magnet to the correct

position, the bike will function normal again. Otherwise contact your dealer.

* only for ebikes with mid engine

1. Connect the charger (A) to the mains voltage (B).

2. Connect the chargerplug (C) of the charger to the contact point of the

battery pack (D).

3. The indicator lamp glows red while the battery is still charging. When the

battery pack is fully charged, charging will stop automatically after 24

hours. The small lamp on the charger will continue to glow green.

Table des Matières