Cancelling A Programme; Opening The Lid; At The End Of The Programme - Zanussi ZWQ 71235SI Notice D'utilisation

STARTING A PROGRAMME WITH THE
FINISH IN OPTION
1. Touch the button
choose the number of hours in which you want
the washing cycle to be finished.
The display shows the number of hours you set
(e.g. ) and the indicator above the button
on to show that his option is active.
2. Touch the button
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Finish In option before you touch
the button
button you can only cancel the
Finish In option.
To cancel the the Finish In option:
a. Touch the button
to pause. The indicator of button
flashes.
b. Touch the button
above this button goes off.
Touch the button
programme immediately.
When using liquid detergents in
combination with the Finish In option,
add the liquid detergents with a
dosing ball (supplied by the
detergent's manufacturer).
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Touch .
The indicator of this button flashes.
2. Change the options. If you change any option
the Finish In option (if set) will be disabled.
3. Touch again.
The programme continues.

CANCELLING A PROGRAMME

1. Press the button On/Off for some seconds to
cancel the programme and to deactivate the
appliance.
again and again to
:
. After touching the
to set the appliance
until the indicator
again to start the
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
is
not fill the detergent again.

OPENING THE LID

While a programme (or the
appliance lid is locked. The indicator
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the lid.
To open the lid during the first minutes of the
cycle (or when the
1. Touch the button
2. Wait a couple of minutes until the indicator
goes off.
3. You can open the lid.
4. Close the lid and touch the button
The programme (or the

AT THE END OF THE PROGRAMME

• The appliance stops automatically.
• The acoustic signal operates (if it is activated).
• In the display
• The indicator of the button
• The lid lock indicator
unlocking) and then goes off.
• You can open the lid.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
• Press the button
deactivate the appliance.
• Close the water tap.
• Keep the lid ajar, to prevent the mildew and
odours.
The washing programme is completed, but
there is water in the drum:
• The drum turns regularly to prevent the creases
in the laundry.
• The indicator
the water.
• The lid lock indicator
button flashes. The lid stays locked.
) operates, the
operates) :
to pause the appliance.
) continues.
comes on.
goes off.
blinks (when the lid is
for some seconds to
flashes to remind you to drain
is on. The indicator of
is on.
again.
11