Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DAILY USE

WARNING! Refer to Safety chapters.
LOADING THE LAUNDRY
1. Open the appliance lid.
2. Push the button A.
The drum opens automatically.
3. Put the laundry in the drum, one item at a time.
4. Shake the items before you put them in the
appliance.
Make sure not to put too much laundry in the drum.
5. Close the drum and the lid.
CAUTION! Before you close the lid of
your appliance, make sure that you
close the drum correctly.
USING DETERGENT AND ADDITIVES
1. Measure out the detergent and the fabric
conditioner.
2. Put the detergent and the fabric conditioner
into the compartments.
10
DETERGENT COMPARTMENTS
ACTIVATING THE APPLIANCE
Press and hold for a couple of seconds the On/Off
button to activate or deactivate the appliance.
A tune sounds when the appliance is activated.
The display shows the word On.
A
SETTING A PROGRAMME
1. Touch the programme button
programme:
The indicator of the button
The display shows the programme duration.
2. If necessary, change the temperature and the
spin speed or add available options. When you
activate an option, the indicator of the set
option comes on.
If you set something incorrect, the
display shows the message
STARTING A PROGRAMME WITHOUT THE
FINISH IN
Touch the button
The indicator of the button
flash and stays on.
The programme starts, the lid locks, the
indicator
The drain pump can operate for a short time
at the beginning of the washing cycle.
After approximately 15 minutes from
the start of the programme:
The appliance adjusts automatically
the programme duration agree with
the laundry load.
The display shows the new value.
Detergent compartment for pre-
wash phase.
Detergent compartment for wash-
ing phase.
Compartment for liquid additives
(fabric conditioner, starch).
CAUTION! Do not
exceed the
M
level.
and set the
OPTION
.
is on.
flashes.
.
stops to

Publicité

Table des Matières
loading

Table des Matières