Cancelling A Programme; Opening The Door - Zanussi ZWF 91483WH Notice D'utilisation

a. Touch the button
appliance to pause. The indicator of
button flashes.
b. Touch the button
above this button goes off.
Touch the button
programme immediately.
Interrupting a programme and changing
the options
You can change only some options before they
operate.
1. Touch .
The indicator of this button flashes.
2. Change the options. If you change any
option the Finish In option (if set) will be
disabled.
3. Touch again.
The programme continues.

Cancelling a programme

1. Press the button On/Off for some seconds
to cancel the programme and to deactivate
the appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water.
In this case, make sure that the
detergent is still in the detergent
compartment, if not fill the detergent
again.

Opening the door

While a programme (or the
appliance door is locked. The indicator
on.
CAUTION!
If the temperature and level of the
water in the drum are too high, you
cannot open the door.
To open the door during the first minutes
of the cycle (or when the
1. Touch the button
appliance.
2. Wait until the indicator
12
All manuals and user guides at all-guides.com
to set the
until the indicator
again to start the
) operates, the
is
operates) :
to pause the
goes off.
3. You can open the door.
4. Close the door and touch the button
again. The programme (or the
continues.
At the end of the programme
• The appliance stops automatically.
• The acoustic signal operates (if it is
activated).
• In the display comes on.
• The indicator of the button
• You can open the door.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Press the button
deactivate the appliance.
• Close the water tap.
• Keep the door and the detergent drawer
ajar, to prevent the mildew and odours.
The washing programme is completed,
but there is water in the drum:
• The drum turns regularly to prevent the
creases in the laundry.
• The indicator flashes to remind you to
drain the water.
• The door lock indicator
indicator of button
stays locked.
• You must drain the water to open the door.
Draining the water:
1. To drain the water.
• Touch the button
drains the water and spins with the
maximum spin speed for selected
washing programme.
• Alternatively, touch the button
change the spin speed and then touch
the button . The appliance drains the
water and spins. If you set
appliance only drains.
2. Press the button
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
)
goes off.
for some seconds to
is on. The
flashes. The door
. The appliance
to
, the
for some seconds to
www.zanussi.com