Technical Data - Zanussi ZWQ 71235SI Notice D'utilisation

Problem
The appliance fills with wa-
ter and drain immediately.
The cycle is shorter than
the time displayed.
The cycle is longer than
the time displayed.
The washing results are
not satisfactory.
You cannot set an option.
After the check, activate the appliance. The
programme continues from the point of interruption.
If the problem occurs again, contact the Authorised
Service Centre.
If the display shows other alarm codes. Deactivate
and activate the appliance. If the problem
continues, contact the Authorised Service Centre.

TECHNICAL DATA

Dimension
Electrical connection
Level of protection against ingress of solid particles and
moisture ensured by the protective cover, except where
the low voltage equipment has no protection against
moisture
Water supply pressure
1)
Water supply
Maximum Load
Energy Efficiency Class
Spin Speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
16
• Make sure that the drain hose is in the correct position. The end of
the hose may be too low. Refer to 'Installation instruction'.
• The appliance calculates a new time according to the laundry load.
See the 'Consumption Values' chapter.
• An unbalanced laundry load increases the duration time. This is a
normal behaviour of the appliance.
• Increase the detergent quantity or use a different detergent.
• Use special products to remove the stubborn stains before you
wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Make sure that you press only the wanted touch button(s).
SERVICE
We recommend the use of original spare parts.
When contacting the Authorised Service Centre,
make sure that these data are available. You can
find the information on the rating plate: model, PNC
and Serial Number. (Mod., Prod. No., Ser. No.)
Width/ Height/ Depth/ To-
tal depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
Cotton
Maximum
Possible solution
400 mm/ 890 mm/ 600 mm/ 600 mm
230 V
2200 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
7 kg
A+++
1200 rpm