Operating The Device; Setting The Channel - Topcom BABYTALKER 1020 Manuel D'utilisateur

®
5.4.2 Connecting the baby unit to the mains
- Plug the small connector of the power adapter into the
power adapter jack
indicates, the jack is locked into position.
- Connect the power adapter (7,5V DC / 300mA) to a mains
socket (230-240V~ 50Hz).
• Only use the enclosed power adapter.
5.4.3 Inserting batteries into the parents' unit
WARNING
Injury and material damage can be caused by using
non-rechargeable batteries in the parents' unit!
• Only use the Ni-MH battery pack supplied with the
product.
• The parent unit can only be used with the
enclosed a Ni-MH battery pack. It cannot
be used with single cell Ni-MH batteries!
- Remove the belt clip.
- Push the battery cover
- Install the rechargeable battery pack following the polarity as
illustrated.
- Re-install the battery cover
5.4.4 Charging batteries in the parents' unit
- Connect the power adapter (7,5V DC / 300mA) to a
main socket (230-240V~ 50Hz).
- The flashing battery charge indicator in the display
shows that the batteries are being charged:
• The batteries take about 12 hours
to charge.
• The batteries are charged continuously.
Therefore the flashing battery charge
indicator in the display is still visible even
when the batteries are fully charged.
6

Operating the device

6.1 Switching the parents' unit and baby unit on and off
- Press the on/off button
- To switch on the baby unit, press the on/off button
- To switch off the parents' unit, press and hold the on/off button
- To switch off the baby unit, press and hold the on/off button
6.2

Setting the channel

To have communication between the baby unit and the parents' unit they need to be set both on the same channel.
- Press the channel up
unit.
- Press the channel up
the parent unit.
Once both units have the same channel, the parents' unit can receive the signal from the baby unit.
When on one or both units is displayed, the privacy mode is activated. Check chapter "Activating privacy mode"
on page 7
.
6
on the side of the baby unit. A click
22
and slide it downwards.
13
and belt clip.
13
to switch on the parents' unit. The display
9
or channel down
3
or channel down
15
. The display
18
until the display goes out
9
until the display goes out.
18
button on the parent to select the channel of the parent
4
button on the baby unit to select the same channel of
16
Babytalker 1020
Ni-MH
MUST BE RECYCLED OR DISPOSED OF PROPERLY
MADE IN CHINA
illuminates.
illuminates.
14