Basic Safety Instructions; Construction And Function - Topcom BABYTALKER 1020 Manuel D'utilisateur

®
2.2 Use of batteries
WARNING
Danger due to incorrect use!
The incorrect use of batteries can be dangerous.
• Only use batteries of the same type.
• Ensure that you observe the correct polarity when inserting batteries. Incorrect polarity will
damage the batteries and the device.
• Never throw batteries in the fire as they may explode.
• The ends of batteries must never be accidentally or deliberately place in contact with each
other or allowed to touch metal objects. This leads to overheating, explosion or fire.
• Keep batteries out of the reach of children. Seek medical advice immediately if batteries are
swallowed.
• Leaking battery acid can cause lasting harm to the device.
Be very careful when handling damaged or leaking batteries. Danger of chemical burns! Wear
protective gloves.
• Remove the batteries if the device is to remain unused for an extended period.
2.3

Basic safety instructions

Follow the safety instructions given below in order to use the device safely:
- The device must be assembled by an adult. Keep small parts out of the reach of children during assembly.
- Do not allow children to play with the device or its parts.
- Make sure that the device and the cables are always out of the baby's reach.
- Never cover the device with a towel, blanket etc.
- Any defective components must be replaced using original spare parts. Only these parts are certain to
meet the safety requirements.
- Shut off your device in all places where posted information requires you to do so. Hospitals and healthcare
facilities may use devices which react sensitively to external high frequencies.
3

Construction and function

This babyphone comprises a parents' unit and a baby unit, connected by radio according to the PMR 446 standard.
The baby unit starts to broadcast as soon as the microphone picks up a sound. These sounds are transmitted by
the parents' unit. Users can set the sensitivity of the microphone (see page 7).
• The device is not a replacement for responsible and correct adult supervision, it is
only an accessory.
4 Components on the parents' unit
1 Display
2 LED light
3 Channel up button
- Select the next channel
4 Channel down button
- Select the previous channel
5 LED light button
6 Volume down button
4.1 Components on the baby unit
14 Display
15 Channel up button
- Select the next channel
16 Channel down button
- Select the previous channel
17 Set button
18 On/off button
4
(see figure
A
7 Speaker
8 Volume up button
9 On/off button
10 Set button
11 Belt clip
12 Power adapter jack
13 Battery compartment cover
(see figure on the fold-out page).
B
19 Microphone
20 LED Night light button
21 LED Night light
22 Power adapter jack
23 Battery compartment cover
24 VOX sensitivity control
Babytalker 1020
on the fold-out page).