Feeding Timer - Topcom BABYTALKER 1020 Manuel D'utilisateur

Babytalker 1020
IMPORTANT:
When the baby unit is transmitting (TX
set. The channel up
Make sure that the VOX sensitivity switch
and make no excessive sounds while setting the channel of the baby unit.
6.3 Activating privacy mode
The Babytalker 1020 operates on free frequencies (PMR - 446Mhz).
Any other PMR device in range, on the same channel can hear the transmitted babyphone signal.
This means also that the parents' unit can receive the signal from other PMR devices.
To avoid disturbance from other PMR devices, privacy mode must be activated on both parents' and baby unit.
Once the channel on the parents' unit and baby unit is the same,
- Press the set button
- Press the set button
• When privacy mode is activated,
6.4 Setting the transmission volume of the parents' unit
There are 8 volume levels.
- Press the button
8
- Press the button
6
6.5 Setting microphone sensitivity (VOX)
The baby unit operates on VOX mode. This means that the baby unit starts sending as soon as the microphone
detects sound. The sensitivity of the sound detection can be changed by the user.
When you increase the sensitivity, the baby unit picks up quieter sounds.
The VOX sensitivity can be adjusted by turning the VOX sensitivity switch
- Clockwise to the highest VOX sensitivity position
- Counter clockwise to the lowest VOX sensitivity position
6.6

Feeding timer

The feeding timer is a count down timer that can be used for generating an alarm sound to remind you of the next
feeding or medicine time.
To turn on the count down timer and set the timer.
- Press and hold the set button
is displayed.
- Press the channel up
- Press the channel up
- Press the set button
Once the alarm is audible, press any button (except the On/Off button) to deactivate.
• To deactivate the feeding timer during the countdown, enter this menu function
again and reset the hour and minutes to zero.
6.7 Night light on the baby unit
- Press the night light button
- Press the night light button
6.8 LED light on the parents' unit
- Press the LED light button
- Press the LED light button
or channel down
15
once to activate privacy mode on the parent unit.
10
once to activate privacy mode on the baby unit.
17
to increase the volume.
to decrease the volume.
for 5 seconds. The feeding timer icon and feeding time interval
10
button to select the hour.
3
button to select the minutes.
4
to confirm.
10
to activate the LED night light
20
again to deactivate the LED night light
20
to activate the LED light
5
again to deactivate the LED light
5
on the display), the channel cannot be
32
button will not respond.
16
is set to minimum (Counter clockwise)
24
is displayed.
;
24
.
21
.
21
.
2
.
2
®
7