Operation And Use; Setting The Display Language - Topcom KIDZZZ BABYTALKER 3500 SEDS Manuel D'utilisateur

– Fit three AA alkaline cells (LR06/Mignon) in the battery compartment.
Ensure that the polarity is correct.
– Close the battery compartment.
• Never mix used cells with fresh cells.
8.3 Connecting the Baby Unit to the AC Mains
Insert the small plug of the AC mains adapter in the mains power
connector of the baby unit
mains connector (230 V / 50 Hz).
CAUTION
• The mains connector must be within easy reach so you can
quickly unplug the power cable in an emergency.
• Use only the supplied AC mains adapter (6 V DC / 300 mA).
8.4 Installing Rechargeable Batteries in the Parent Unit
See Figure B on the fold-out page.
CAUTION
• Use only the supplied NiMH battery pack in the parent unit.
– Rotate the belt clip
– Turn the screw on the cover
of the parent unit 90° counterclockwise and remove the battery
compartment cover.
• Do not turn the screw past the 'Open' point.
– Place the NiMH battery pack in the battery compartment.
Ensure that the tab of the battery pack fits in the corresponding recess
and that the polarity matches the figure (B).
– Carefully close the battery compartment and rotate the belt clip back
downward.
8.5 Installing Rechargeable Batteries in the Parent Unit
– Insert the small plug of the AC mains adapter in the mains power connector
plug the AC mains adapter into a mains connector (230 V / 50 Hz).
– Place the parent unit in the charging station. The red Charging LED
• It takes around 10 hours to fully charge the batteries.
9

Operation and Use

9.1 Switching the Baby Unit and Parent Unit On and Off
– Press the On/Off switch
– Press the On/Off switch
• The parent unit will try to establish a connection with the baby unit. If the Link LED
on, a connection has been established. If it does not, see page 12.
– Press the On/Off switch
– Press the On/Off switch
9.2

Setting the Display Language

– Press button
6
and plug the AC mains adapter into a
14
upward.
30
of the battery compartment at the back
31
to switch on the parent unit. The display
29
to switch on the baby unit. The display
12
to switch off the parent unit (press and hold until the display goes blank).
29
to switch off the baby unit (press and hold until the display goes blank).
12
. 'Night light'is displayed.
23
Babytalker 3500 SEDS
SEDS
1 x A A
LONG
+
ECO 1 x A A
SEDS
LONG
6V/300mA
ECO
of the charging station and
32
will go on.
33
is activated.
22
is activated.
3
6V/300mA
-
OPEN
B A
+
goes
21