Cleaning And Maintenance; Safety Instructions - Topcom KIDZZZ BABYTALKER 3500 SEDS Manuel D'utilisateur

Babytalker 3500 SEDS
– Press button
27
– Repeat the previous two steps to set the minutes.
– After setting the minutes, press button
– Press button
23
9.9 LED Torch
The parent unit has a built-in LED torch
– Press button
25
10

Cleaning and Maintenance

This section contains important instructions for cleaning and maintaining the equipment.
Follow these instructions to ensure trouble-free use and prevent damage to the equipment due to improper
maintenance.

10.1 Safety Instructions

DANGER
Risk of fatal injury due to electric shock!
• Before cleaning the equipment, switch it off and unplug the power cable from the mains receptacle.
CAUTION
Risk due to leaking battery fluid
Fluid from leaking batteries (regular or rechargeable) can cause injuries (skin irritation) or damage to the
equipment. Wear safety gloves.
CAUTION
• Do not use cleaning products or solvents. They can damage the case or seep into the equipment and
cause permanent damage.
10.2 Cleaning
– Clean the equipment with a soft, slightly dampened cloth.
– Clean soiled connectors and contacts with a soft brush.
– Clean the battery contacts and battery compartment with a dry, lint-free cloth.
– If the equipment gets wet, switch it off and remove the batteries immediately.
Wipe the battery compartment dry with a soft cloth in order to minimise potential water damage.
Leave the battery compartment open until it is completely dry.
Do not use the equipment before it is completely dry.
10.3 Maintenance
– Check the batteries (regular or rechargeable) in the equipment regularly and replace them when necessary.
– Check the connectors and cables for defects.
CAUTION
• If you suspect that the equipment is damaged, always have it checked by an expert before using it
again.
11 Troubleshooting
This section provides important instructions for localising and correcting problems.
Follow these instructions in order to avoid hazards and damage.
11.1 Safety Instructions
DANGER
Risk of fatal injury due to electric shock!
• Unplug the power cable before attempting to correct a problem.
.
27
to exit the menu.
.
19
to switch on the LED torch.
to confirm the setting.
11