Electronic Speed Controller (Esc); Factory Defaults - Arrma 4x4 Mode D'emploi

Electronic Speed Controller (ESC)

If using LiPo batteries you must set the correct battery mode on the ESC
(electronic speed controller) to prevent battery damage.
Motor Connectors
Battery Plug
Throttle Setup
Do not move the throttle when switching the model on as the ESC will
automatically set the throttle neutral. A long beep will sound to confirm
setup.
ESC Specifications
Input Voltage 6-7 NiMh (7.2-8.4v) / 2S Lipo (7.4v)
ESC Status LED
Low Voltage Cut Off
Battery Mode
Cut-off Voltage

Factory Defaults

© 2017 ARRMA Durango Ltd. A subsidiary of Hobbico, Inc.
Setting 'Jumpers'
LED off: Neutral throttle
LED blinking slowly: Partial Forward/Reverse/Brake
LED solidly on: Full Forward/Reverse/Brake
NiMh
4.5v
Heat-sink
Power Switch
LiPo
6.4v
Battery Mode: NiMh
Reverse: On
12
HEAT-SINK MAY BE HOT AFTER USE
Receiver Plug
BEC Output 6.0v/2A Max
(CH2)