Arrma 4x4 Mode D'emploi page 15

CH1-
NOR REV
ST
CH2-
NOR REV
TH
Binding
Remove receiver
box lid
Press and hold
End Point Adjustment
To enter programming
mode:
Turn steer-wheel left or
Place vehicle off the
ground and switch
on
Factory Defaults
Steering CH1/Throttle CH2 channels see table. Steering and Throttle trim set to middle/zero
adjustment. Steering Dual Rate at 100% fully left.
Switch on Car
bind button
Turn steer-wheel fully
right
Steering End Points
Grip buttons move end
right
Receiver LED will
blink
Apply full throttle
Power on Transmitter
(pull)
point
Always Turn off car first and then transmitter to save settings
15
LED stops blinking
Switch on
transmitter
Power LED will flash
Throttle End Points
Apply throttle or The grip buttons
brake adjust the end points
five times