Throttle Setup; Esc Status Led; Factory Defaults - Arrma 4x4 570 MEGA Mode D'emploi

WARNING: When using LiPo batteries, always ensure the ESC is set to the correct battery
mode. Failing to do so may damage to the battery. Charging or using a damaged battery could
Motor Connectors
Battery Plug

Throttle Setup

Do not move the throttle when switching the model on as the ESC will
automatically set the throttle neutral. A long beep will sound to confirm
setup.
Input Voltage

ESC Status LED

Low Voltage Cut Off
Battery Mode

Factory Defaults

Setting 'Jumpers'
6-7 NiMh (7.2-8.4v) / 2S LiPo (7.4v)
LED blinking slowly: Partial Forward/Reverse/Brake
LED solidly on: Full Forward/Reverse/Brake
Heat-sink
NiMH
4.5v
Battery Mode: NiMH
Reverse: On
19
CAUTION: Heat sink may be hot after use.
Power Switch Receiver Plug
BEC Output
LiPo
6.4v
WWW.ARRMA-RC.COM
(CH2)
6.0v/2A Max