Electronic Speed Controller (Esc) - Arrma VORTEKS 4X4 3S BLX Vehicle Notice D'utilisation

Electronic Speed Controller (ESC)

Only use fully charged LiPo batteries (4.2V per cell) to prevent
battery/ESC damage.
Motor wires x 3
Power Switch & Set button
Input Voltage
Minimum Req. 6-8 Cell NiMh (7.2v-9.6v)
Throttle
Connect batteries, turn on TX and press/hold the set button 'A'. Turn the switch on
Setup
'B' and release the set button when the RED light flashes on the ESC.
1. TX in neutral - press set
button (1 Green flash)
Battery Plug
ESC Specifications
2S-3S LiPo (7.4-11.1v) 50C 5000mAh
2. TX full throttle - press set
button (2 Green flashes)
4. Switch off ESC to complete setup
BEC Output 6.0v/4A Max
3. TX full brake - press set
button (3 Green flashes)
17
WARNING: Heat sink
may be hot after use.
Receiver Plug (CH2)
B
A
WWW.ARRMA-RC.COM