Adjusting Ph Set Point - Davey DPLGEU Mode D'emploi

8.1.1. Adjusting pH set point

The factory default pH set point is 7.4, however you may wish to change this once the Davey Lifeguard is
installed. It should be noted that Chlorine's effectivity is greatly influenced if pH levels are too high, or too
low. Davey recommends following the pool chemistry levels shown in Section 10. Adjustments to pH set
point can be made as follows.
8.1.1.1. On the Davey Lifeguard control panel
• From the HOME SCREEN, press the
main menu (Figure 8.3);
Figure 8.3
• Press the
Figure 8.4
• Press the menu/setting select button. This will now show the settings menu (Figure 8.5);
Figure 8.5
• Press the menu/setting select button. The next screen ask "is the pH probe connected?"
(Refer Figure 8.6);
menu/setting select button. This will now show the
main:
-> modes
settings
maintenance
menu up/down button to scroll down to settings (Figure 8.4);
main:
modes
-> settings
maintenance
settings:
-> ph set point
orp set point
language
30
▲ CONTENTS