Firmware Updates - Davey DPLGEU Mode D'emploi

• Davey recommends watching the demo video (refer Figure 7.2) that shows how to create a user profile
and connect your smart device to Lifeguard. The demo video can be viewed from:
https://www.daveywater.com/resources/pool/LG_App_1stTimeSetup.mp4 The demo video walks
through the initial setup of connecting the Davey Lifeguard controller to the internet.
This symbol confirms Davey Lifeguard's connection to EcoSalt2. If the "N" is flashing,
Lifeguard is attempting to connect. If the "N" is solid, the connection is made;
This symbol confirms Davey Lifeguard's connection to the internet. If the symbol
is shown solid, it indicates that Davey Lifeguard is connected to the internet. If it is
flashing, Davey Lifeguard isn't connected to the internet; and
This symbol shows the signal strength of the local wifi.
If the symbol is solid, the Lifeguard WiFi is connected to the router.
If it is flashing, the Lifeguard WiFi is NOT connected to the router.
Figure 7.3

7.1 FIRMWARE UPDATES

As is the case with most "smart devices", it is important to ensure that your Davey Lifeguard and
Davey EcoSalt2 has the latest revision of firmware. When a critical firmware update is released, your
Davey Lifeguard &/or EcoSalt2 will require updating over the air (OTA), as long as they are correctly
connected to the internet. When connecting the Davey Lifeguard to the internet for the first time,
and periodically after installation. Davey recommend forcing an OTA firmware update of both the
Lifeguard and EcoSalt2. It is important to start with the Lifeguard:
• On the Lifeguard controller, hold down the
• The display will go blank.
• Then the words "software update in progress" will appear on the display.
Figure 7.2
system on 100%
slt 0 t 26°c
orp 459 ph 7.4
menu down button for approx 5 seconds.
28
▲ CONTENTS