Temp Probe Menu; Initial Pool Chlorination; Connecting Davey Lifeguard To Wifi - Davey DPLGEU Mode D'emploi

• Place the salt probe into the TDS solution, press the
3000ppm, then press
• Carefully unscrew the bottom half of the bottle, from the bottle's lid. Follow the same process outlined
for the pH probe (refer Section 6.5).

6.8 TEMP PROBE MENU

• The next screen asks if the temperature probe is currently connected and to be used (refer Figure
6.27). The temperature probe is the same probe as the salt probe, but it does plug into the Davey
Lifeguard controller by a separate socket;
Figure 6.27
• Use the menu up/down buttons to toggle between yes and no.
• Once correct, then press
• If you've chosen to use the temperature probe, use the
current temperature of the pool's water.

6.9 INITIAL POOL CHLORINATION

For a pool installation that has not been chlorinated, add sufficient chlorine (liquid, or granular) to achieve
a reading of 3 ppm (with a suitable test kit). Alternatively, run the EcoSalt2 continuously on BOOST
MODE, for approximately 24 hours, or until a reading of 3 ppm is reached.

7. CONNECTING DAVEY LIFEGUARD TO WiFi

Connecting your Davey Lifeguard to WiFi means you can monitor and control your pool remotely via the
app and staying connected will mean you have access to the latest software updates for the device.
Note: Home Wi-Fi name (SSID) or password cannot be more than 18 characters
Before you connect to WiFi ensure you have a strong WiFi connection at the pool equipment area
where the Davey Lifeguard is installed. At minimum (and most reliable for Lifeguard) the Download
speed should be at least 12Mbps for Lifeguard. Use https://www.speedtest.net/ to test the WiFi network
download/upload speed. You may need to extend your WiFi signal by purchasing a WiFi repeater. Make
sure your WiFi is 2.4 GHz. Davey recommends the use of following Wifi Extenders:
* The TP-LINK RE450;
* The Netgear EX6250; or
* Netgear Nighthawk EX7300.
Should you wish to connect your Davey Lifeguard to WiFi, follow these steps, otherwise skip to the next
section. You can connect to WiFi at anytime.
• From the app store (or Apple Store), download the DAVEY LIFEGUARD app.
• Open App on smart device
• Create an account
• Go to your Davey Lifeguard module, turn on
Bluetooth in the settings menu by entering
the password 1234
• With your smart device connected to WiFi, connect your
Davey Lifeguard to the internet
menu/setting select;
is temp probe
connected?
->yes
menu/setting select;
27
menu up/down buttons to scroll to show
menu up/down buttons to display the
Figure 7.1
Lifeguard
▲ CONTENTS