Zeiss Axio Observer Mode D'emploi Succinct page 18

ZEISS
Axio Observer 3
40
Binocular section of tube
41 Eyepiece
42 Eyepiece focusing ring
Fig. 3 Axio Observer and power supply
unit (ballast unit) for HBO 100
Axio Observer 5, 5 materials:
• Switch the microscope on and off using the standby button (Fig. 3/1).
Axio Observer 7, 7 materials:
• Switch on the external power supply unit VP232-2 using the power switch.
• Start up the microscope using the standby button (on the left of the stand, Fig. 3/1).
• For fluorescence applications, switch on the fluorescent illumination source (e.g. power supply unit for
HBO 100, Fig. 3/2), if required.
GENERAL WORKING ADVICE
The monitoring LED (Fig. 3/3) lights up when the microscope is switched on.
16
SWITCHING ON SAFELY
Axio Observer 5
Binocular section of tube
Eyepiece
Eyepiece focusing ring
11
The Axio Observer microscope is delivered in a
partially assembled condition. It can be set up and
calibrated by the customer himself or through the
ZEISS service.
Please refer to the chapter "INSTALLATION
INSTRUCTIONS AND FIRST-TIME SET-UP" in the
complete operating manual.
Switching ON the microscope and the power
supply unit for the HBO 100
• Remove the dust covers from the instrument.
Axio Observer 3, 3 materials:
• Switch
On / Off switch (on the left of the stand,
Fig. 3/1).
431004-6044-008
Axio Observer 7
Binocular section of tube
Eyepiece
Eyepiece focusing ring
SWITCHING ON SAFELY
the microscope on
Axio Observer
using the
09/2017