Dometic 10-Série Notice D'utilisation page 36

Troubleshooting
RML10.4,
RML10.4T
RML 10.4S
E03
E07
E08
E09
E12
E13
E14
E50
36
Fault
No connection between
power module and display
No cooling capacity in gas
mode
No cooling capacity in AC
power mode
No cooling capacity in DC
power mode
Gas valve test error
Internal communication error Gas operation not possible.
In stand-alone gas mode:
The battery charge of the
battery packs is too low
Gas lock after 3 ignition
attempts
RML10.4, RML10.4S, RML10.4T
Solution
Contact an authorized customer
service point.
Check if the device is at an angle
and adjust it so it is level, if neces-
sary.
Reset the error.
Contact customer service if this
error occurs again.
Check if the device is at an angle
and adjust it so it is level, if neces-
sary.
Reset the error.
Contact customer service if this
error occurs again.
Check if the device is at an angle
and adjust it so it is level, if neces-
sary.
Reset the error.
Contact customer service if this
error occurs again.
Gas operation is not possible.
Reset the error.
Contact customer service if this
error occurs again.
Reset the error.
Contact customer service if this
error occurs again.
Insert new batteries and then reset
the error.
Ignition not possible.
The gas cylinder is empty. Replace
the gas cylinder.
Reset the error.
EN