Replacing Components - Modular 70/80 BRE Série Manuel D'installation, D'emploi Et D'entretien

PILOT BURNER GOES OUT DURING USE.
Possible causes:
- Insufficient gas supply pressure.
- Defective gas tap or valve.
- Defective thermocouple or insufficient heating.
- Thermocouple incorrectly connected to gas tap or
valve.
-
Knob of gas tap or valve not pressedsufficiently.
THE MAIN BURNER DOES NOT LIGHT (EVEN
THOUGH PILOT IS LIT).
Possible causes:
- Insufficient gas supply pressure.
- Blocked tubing or nozzle.
- Defective gas tap or valve.
- Defective burner (gas outlet holes clogged).
-
Defective energy regulator.
HEATING CANNOT BE ADJUSTED.
Possible causes:
-
Defective energy regulator.
DIFFICULT OR NOISY OPERATION OF THE PAN
MOVING DEVICE
- Worn screw nuts require replacement.
- Poor engagement of moving parts (screw, nuts,
bolt, pins, levers, etc...).
ELECTRIC BRATT PAN
THE APPLIANCE DOES NOT HEAT.
Possible causes:
- Heating elements defective.
- Temperature thermostat defective.
- Safety thermostat tripped.
HEATING CANNOT BE ADJUSTED.
Possible causes:
- Temperature thermostat defective.
DIFFICULT OR NOISY OPERATION OF THE PAN
MOVING DEVICE
- Worn screw nuts require replacement.
- Poor engagement of moving parts (screw, nuts,
bolt, pins, levers, etc...).
MULTI-PURPOSE APPLIANCE
THE APPLIANCE DOES NOT HEAT.
Possible causes:
- Temperature thermostat defective.
- Heating elements defective.
- Safety thermostat tripped.
HEATING CANNOT BE ADJUSTED.
Possible causes:
- Temperature thermostat defective.
20.

REPLACING COMPONENTS

REMINDERS FOR REPLACING COMPONENTS
SHUT THE GAS SHUT-OFF VALVE
AND/OR SWITCH THE APPLIANCE OFF
AT THE MAIN SWITCH INSTALLED
UPSTREAM.
AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS
AT CONNECTION POINTS.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE CARRYING
OUT ANY OPERATION.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
29