Sanremo ROMA TCS SED Mode D'emploi page 56

ENGLISH
CHRONO FUNCTION
The CHRONO function can be activated in the TECHNICAL LEVEL Programming (see paragraph). It enables the time of coffee distribution to be
displayed in seconds for the respective groups. As soon as a dose is activated, the following is displayed:
the display shows:
Where
- XXX is the drink selected
- ZZZ are the seconds which increase even when the flow meter receives no pulses.
This is displayed for 5 seconds from the end of the last distribution, after which IDLE-ON is again displayed.
In the event of simultaneous distribution, the selections are displayed in succession from the first to the last.
In the event of a flow meter alarm, the alarm is displayed until interruption of the dose by the user (or due to flow meter time-out), after which the
duration of the dose is displayed for 5 seconds.
DISABLING TEMPERATURE DISPLAY
The TEMPERATURE DISABLING function can be activated in the TECHNICAL LEVEL Programming (see paragraph). It disables display of the tem-
perature measured by the boiler temperature probe.
the display shows:
Where the message ON identifies activation of the heating remote switch ON/OFF relay by the user.
DISTRIBUTION GROUPS WASHING
To active the DISTRIBUTION GROUPS WASHING CYCLE, with the doser in IDLE-ON state,
just press the continuous button (K5GRx) and then the first dose button (K1GRx) corre-
sponding to the group you want to wash. LEDs L5GRx and L1GRx corresponding to the
group concerned start flashing to confirm that the washing cycle is underway.
Washing is performed by energising the EVx actuators (where X may be 1, 2 or 3 corre-
The cycle consists of energising of the PUMP and EVx actuators for 7 seconds, followed by de-energising for a further 3 seconds. This is repea-
ted 5 times. At the end of a washing cycle, the system automatically switches back to the IDLE-ON state.
NOTE: washing may be performed as many times as you wish and simultaneously on three groups.
NOTE1: you can interrupt the washing cycle before conclusion by pressing any distribution button for the group concerned.
STEAM WAND/CAPPUCCINO MAKER WASHING (IF PRESENT ON THE SLAVE BOARD)
To active the STEAM WAND/CAPPUCCINO MAKER WASHING CYCLE, with the doser in IDLE-
ON state, just press button K5GRx then the button (K1GRx) corresponding to the group on
which the steam is active. The L6GRx LED corresponding to the group concerned remains lit
to confirm that the washing cycle is underway. The other LEDs in the group switch off.
Washing is performed by energising the EVVAP and EVLAV actuators according to the
times shown below.
NOTE: you can interrupt the washing cycle before conclusion by pressing any distribution button for the group concerned.
NOTE1: you can distribute coffee and tea from all groups during steam wand washing.
Brewing Gr:x
xxxxxx
ON hh:mm
SANREMO
sponding to the
group being
washed) and
PUMP actuators
according to the
times shown below.
The cycle consists of energising EVVAP for 10 seconds, then alternating
EVLAV for 2 seconds and EVVAP for 2 seconds. This is repeated 5
times. At the end, EVVAP remains energised for 12 seconds. At the
end of a washing cycle, the system automatically switches back to the
IDLE-ON state.
56
zzz