Access The Spark Plug - Snapper 1695880 Manuel De L'opérateur

Add Oil
1. Place engine level.
2. Clean the oil fill area of any debris.
3. See Specification section for oil capacity.
4. Remove the dipstick (C, Figure14) and wipe with clean
cloth.
5. Pour the oil slowly into the engine oil fill (D). DO NOT
overfill. Wait one minute and recheck the oil level.
6. Install and tighten dipstick.
7. Remove the dipstick and check the oil level. It should be
at the top of the full indicator (E) on the dipstick.
8. Install and tighten dipstick.
C
D
Figure 13
en

Access the Spark Plug

To access the spark plug, the snow hood must be removed
as follows:
1. Remove the ON/OFF key (A, Figure 15) or pull out the
2. Grasp the choke control (B) and pull up to remove.
3. Remove the mounting screws (C).
4. Carefully remove the top part of the snow hood (D). DO
5. Remove the spark plug (G) and replace. (See
E
G
F
E
Figure 14
6. Before installation of the snow hood, make sure the
7. Mount the top of the snow hood to the snow hood base.
8. Align the slots (H, Figure 15, Inset) in the choke knob
9. DO NOT install the ON/OFF or Push/Pull key until you
ON/OFF switch or Push/Pull key. Keep the key away
from children.
NOT disconnect the primer hose (E) or the key wire (F).
Specifications).
B
C
primer hose and the key wire are connected.
Make sure the top interlocks with the base. Secure with
mounting screws .
with the tabs on the choke shaft (I) and push down to
install. If knob is not installed correctly, the choke will
not operate.
are ready to start the engine.
Maintenance
H
I
A
D
19