Stop The Engine - Snapper 1695880 Manuel De L'opérateur

Operation
If the extension cord is damaged, it must be
replaced by the manufacturer (or its service
agent) or a similarly qualified person to avoid a
hazard.
7. Electric Start: First connect the extension cord (E,
Figure 6) to the power cord receptacle (F) and then
into a wall receptacle. If additional extension cord is
required, make sure it is three-wire.
8. Electric Start: Depress the starter push button (G).
After you start the engine, first disconnect the extension
cord from the wall receptacle and then from the power
cord receptacle.
Important: To extend the life of the starter, use short
starting cycles (five seconds maximum). Wait one
minute between starting cycles.
NOTE: If the engine does not start after three attempts,
see the Troubleshooting section in the Engine Manual.
G
F
E
Figure 6
14
WARNING

Stop the Engine

Gasoline and vapors are extremely flammable
and explosive. Fire or explosion can cause
severe burns or death. DO NOT choke the
carburetor to stop the engine.
Before stopping the engine, allow it to idle for a few minutes
to help dry off any moisture.
1. Turn the ON/OFF or Push/Pull key (A, Figure 7) to the
OFF position and remove or pullout the Push/Pull key if
equipped.
2. Keep the ON/OFF or Push/Pull key out of the reach of
children. The engine cannot be started without the ON/
OFF or Push/Pull key.
A
Figure 7
WARNING
www.snapper.com