Stop The Snowthrower - Snapper 1695880 Manuel De L'opérateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation

Stop the Snowthrower

Read Operator's Manual before operating machine. This
machine can be dangerous if used carelessly.
• Never operate the snowthrower without all guards, covers,
and shields in place.
• Never direct discharge towards windows or allow bystanders
near machine while engine is running.
• Stop the engine whenever leaving the operating position.
• Disconnect spark plug before unclogging the impeller
housing or the discharge chute and before making repairs or
adjustments.
• When leaving the machine, remove the safety key. To
reduce the risk of fire, keep the machine clean and free from
spilled gas, oil, and debris.
Never run engine indoors or in an enclosed,
poorly ventilated area. Engine exhaust
contains CARBON MONOXIDE, an
ODORLESS and DEADLY GAS.
• Keep hands, feet, hair, and loose clothing away from any
moving parts on engine and snowthrower.
• Temperature of muffler and nearby areas can exceed 150°F
(66°C). Avoid these areas.
• DO NOT allow children to operate or be near snowthrower
while it is operating.
1. Release the auger control (A, Figure 9).
2. Turn the ON/OFF switch (B) to the OFF position and
remove or pull out PUSH/PULL key.
16
WARNING
WARNING
A
B
Figure 9
Stop the Snowthrower
Never run engine indoors or in an enclosed,
poorly ventilated area. The discharge chute
contains a rotating auger to throw snow. Never
clear or unclog the discharge chute with your
hands.
Fingers can quickly become caught and traumatic amputation
or severe laceration will result. Always use a clean-out tool to
clear or unclog the discharge chute.
Hand contact with the rotating auger inside the
discharge chute is the most common cause of
injury associated with snowthrowers.
• This snowthrower is capable of amputating hands and
feet, and throwing objects. Read and observe all the safety
instructions in this manual. Failure to do so will result in
death or serious injury.
Test - Auger/Impeller
1. Start unit and engage auger control (A, Figure 9).
2. Release auger control.
3. Auger must stop in 5 seconds or less
WARNING
WARNING
www.snapper.com

Publicité

Chapitres

Table des Matières
loading

Table des Matières