Technical Data; Operation - Dustcontrol DC F Tromb Mode D'emploi

c – Plastic bag: The extracted and separated material is collected in a plastic bag that can be detached in one simple operation.
The material can easily be recycled or disposed of.
a - Container: A cylindrical container for collection of separated material.
L – Longopac: The machine is equipped with a flexible bag system, in which the dust is collected in a closed system.

Technical data

HxWxL [mm]
Weight [kg]
Inlet [mm]
Collecting container [l]
Technical Data UK/USA/CAN
HxWxD [in]
Weight [lb]
Inlet [in]
Collecting container [l]

Operation

Emptying
a – Container
The container underneath the cyclone should be emptied when about 2/3 full.
c – Plastic bag
The plastic bag should be replaced when the dust level is about 5 cm below the discharge flap.
L – Longopac
Close the bag using the supplied cable ties when you believe that it has been filled to a suitable level. Another cable tie is used a
little further up. This forms the bottom of the next bag. The filled bag is then cut off, and the machine is ready to be used again.
Changing the bag magazine
1. Rotate the holder to the position in which it can be pulled down.
2. Insert a bag magazine into the holder and refit it.
10
DC F Tromb c DC F Tromb a
1290 x 600 x 780 1290 x 600 x 780
27 33
Ø76 Ø76
20 40
DC F Tromb c
53,5 x 23,5 x 27,5
59
3
20
DC F Tromb, Art.nr. 44754 A
DC F Tromb L
1290 x 600 x 780
32
Ø76
longopac
DC F Tromb a DC F Tromb L
53,5 x 23,5 x 27,5 53,5 x 23,5 x 27,5
73 70
3 3
40 longopac