Working With The Machine; Service And Maintenance; Environment; Eu Declaration Of Conformity - Festool CMS-TS-55-R Notice D'utilisation D'origine

CMS-TS-55-R
GB
• Adjustment parallel to the bench edge - unscrew
the rotary knob [12-8].
• Adjustment at right angles to the bench edge -
unscrew the rotary knob [12-6].
• Adjustment of the stop ruler [12-1] lengthways -
unscrew the rotary knob [12-4]. The stop ruler
can be moved to a lower position for thinner
workpieces (Fig. [12A]) or a higher position for
thicker workpieces (Fig. [12]).
• Angle adjustment using the scale [12-5] - un-
screw the rotary knob [12-3] and lift the retaining
pin [12-2]. The rotary retaining pin engages in
the most common angle positions.
 Turning the retaining pin blocks the stop.
Make sure that all rotary knobs on the stop
are tightened before starting work. The stop
should always be used in a fixed position and
not to slide the workpiece.
9

Working with the machine

Observe the following instructions:
Adjust the top protective cover until it rests on

the workpiece and secure in this position using
the rotary knob [9-2].
Use the fence as a longitudinal stop to guide the

workpiece.
You can adjust the cutting width using the scales

[10-1].
Guide the workpiece by hand. Use the push stick

[12-7] to guide the workpiece safely past the
saw blade.When not in use, place the push stick
in the store [12-9].
10

Service and maintenance

WARNING
Risk of injury, electric shock
Always disconnect the mains plug from the

socket before performing maintenance work on
the machine!
All maintenance and repair work which requires

the motor housing to be opened must only be
carried out by an authorised service workshop.
14
Damaged safety devices and components must be
repaired or replaced in a recognised specialist
workshop, unless otherwise indicated in the oper-
ating manual.
Maintain the machine regularly to make sure it
functions correctly:
Use an extractor to remove dust deposits.

Replace worn or damaged table inserts.

On completion of your work, wind the power ca-

ble around the holders [12-9].
11

Environment

Do not dispose of electric power tools in house-
hold waste! Recycle devices, accessories and
packaging. Observe applicable country-specific
regulations.
EU only: In accordance with European Directive on
waste electrical and electronic equipment and im-
plementation in national law, used electric power
tools must be collected separately and handed in
for environmentally friendly recycling.
Information on REACh: www.festool.com/reach
12

EU Declaration of Conformity

Retaining panel for portable
circular saws
CMS-TS-55-R
Year of CE mark: 2011
We declare under sole responsibility that this prod-
uct complies with all the relevant requirements in
the following directives, standards and normative
documents:
2006/42/EG, 2004/108/EG (until 19.04.2016), 2014/
30/EU (from 20.04.2016), 2011/65/EU, EN 60745-
1:2009, EN 60745-2-5:2010,
1:2006+A2:2011, EN 55014-2:1997+Corrigendum
1997+A1:2001+A2:2008,
A1:2009+A2:2009, EN 61000-3-3:2013.
Festool GmbH
Wertstr. 20, D-73240 Wendlingen, Germany
Dr. Johannes Steimel
Head of Research, Development and Technical
Documentation
2015-03-10
Serial no.
10002996
EN 55014-
EN 61000-3-2:2006+