Working With The Machine; Support Of The Workpieces - Festool TS 55 REQ Guide D'utilisation

Masquer les pouces Voir aussi pour TS 55 REQ:

Guide d'utilisation (55 pages)

Notice d'utilisation d'origine (51 pages)

Notice d'utilisation d'origine/liste de pièces de rechange (124 pages)

Table des Matières

Les langues disponibles

Please observe all mentioned safety infor-

mations and the following rules when work-

ing:

– Check the installation fixture prior to use and do

not use the machine if the fixture does not func-

tion correctly.

– Always hold the machine with two hands at the

handles [1-4] when performing work. This re-

duces the risk of injury and is a prerequisite for

precise work.

– Adapt the fast-feed speed to prevent the cutters

on the saw blade from overheating and prevent

plastic materials from melting during cutting.

– Make sure that all rotary knobs [4-1] are tight-

ened before starting work.

– After the machine has been switched off, the saw

blade will still rotate for a time. Take care that

parts of your body do not come into contact with

the saw blade while it is still rotating!

– Do not work on the power tool if its electronics

are defective as this may lead to excessive

speeds. Defective electronics mean that there is

no smooth start-up and the speed regulation

fails.

For work that generates dust, wear a dust

mask.

Support of the workpieces

Ensure that your workpieces are securely fixed and

cannot move during sawing. Otherwise, there is an

increased risk of accident. Never hold the work-

piece to be cut with your hands or between your

legs. Use instead screw clamps [8-1] or some other

suitable devices to fix your workpiece.

Never position large or long workpieces so that

they bend in the middle or at the cutting face. This