Additional System Programming Using The Keypad - LiftMaster EL1SS Manuel D'installation Et De Configuration

INTRODUCTION

ADDITIONAL SYSTEM PROGRAMMING USING THE KEYPAD

PROGRAM DESCRIPTION OF FUNCTION OR SETTING
NUMBER
7
DELETE ENTRY CODE
9
CREATE A 4-DIGIT ENTRY CODE
NOTES:
• An Entry Code cannot be the same as the Master Code.
• A 4-digit entry code controls 1 relay immediately upon
entry.
CREATE A 5-DIGIT ENTRY CODE
NOTES:
• An Entry Code cannot be the same as the Master Code.
• A 5-digit entry code controls either door selectable at the
time of entry
51 CREATE TEMPORARY (1 TIME) ENTRY CODE
The EL1SS holds 1 temporary Entry Code .
NOTE: An Entry Code cannot be the same as the Master
Code.
52 ENABLE VACATION (LOCK DOWN) MODE
Factory Setting: Disabled
Locks the system from all Entry Code activity .
53 DISABLE VACATION (LOCK DOWN) MODE
54 ENGAGE PARTY MODE (RELAY 1)
Factory Setting: Disabled
Party Mode will latch relay 1 .
INTRODUCTION
56 ENGAGE PARTY MODE (RELAY 2)
Factory Setting: Disabled
Party Mode will latch relay 2 .
NOTE: Output configuration must be in Independent Relay
Control (default) to engage Party Mode on relay 2.
INSTALLATION
Last digit = 1 opens door 1
Last digit = 2 opens door 2
INSTALLATION
TEST
PROGRAMMING STEPS
Master Code (4 digits) + 7
(4 digits)
Master Code (4 digits) + 9
that will be pre-assigned to this entry code) . Wait to hear confirmation
from the system.
Master Code (4 digits) + 9
Resident enters Entry Code
device resident wishes to activate)
NOTE: If no button is pressed for Relay, both relays will activate
simultaneously, unless independent relay output control is enabled.
Master Code (4 digits) + 51
digits) + 1 or 2 (Relay associated with the entry device resident wishes
to activate) or no button is pressed
NOTE: If no button is pressed for Relay, both relays will activate
simultaneously, unless independent relay output control is enabled.
Expires in 24 hours or after first use.
Master Code (4 digits) + 52
Master Code (4 digits) + 53
Master Code (4 digits) + 54
To disengage party mode: Enter a valid
keypad or enter "*9" into the local telephone .
TEST
Master Code (4 digits) + 56
To disengage party mode: Enter a valid
keypad or enter "*5" into the local telephone .
15
SET UP
+ Entry Code that is to be deleted
+ New Entry Code (4 digits) +
+ New Entry Code (4 digits)
+ 1 or 2 (Relay associated with the entry
+ New Temporary (1 Time)
Entry Code
into the EL1SS
SET UP
Entry Code into the EL1SS
1 or 2 (Relay
Entry Code (4