Wiring A Gate Operator (Normally Open) And A; Maglock (Normally Closed) - LiftMaster EL1SS Manuel D'installation Et De Configuration

INTRODUCTION
NOTE: Install a 1N4001
diode or equivalent.
WIRING A GATE OPERATOR (NORMALLY OPEN) & A MAGLOCK
(NORMALLY CLOSED)
INTRODUCTION
The maglock can be connected to Relay 1 or Relay 2 . See the Set Up section for information about configuring Relays 1 and 2 .
INTRODUCTION
DC Power
NOTE: Install a 1N4001
diode or equivalent.
INTRODUCTION
NOTE: Do not use
the unit's power
supply for the maglock.
COM (Common)
INSTALLATION
NC (Normally Closed)
INSTALLATION
INSTALLATION
Maglock
NOTE: Do not use
the unit's power
supply for the maglock.
INSTALLATION
TEST
NO
(Normally Open)
COM
(Common)
TEST
TEST
COM (Common)
COM
(Common)
NC (Normally Closed)
TEST
9
SET UP
Primary Gate Operator
(Strike Open Input)
SET UP
SET UP
Primary Gate Operator
NO
(Strike Open Input)
(Normally Open)
SET UP