Introduction; Cable Requirements; Dimensions; Installation - LiftMaster EL1SS Manuel D'installation Et De Configuration

INTRODUCTION

CABLE REQUIREMENTS

INTRODUCTION
Outdoor installations require shielded cable . Non-shielded cable can be used for indoor installations ONLY .
PROCESSOR BOARD
From the power transformer at 120 Vac outlet
From the door strike, maglock or gate operator
From the strike power supply (if needed)
From the Earth ground to processor board INTRODUCTION
Residence and Telco phone lines
INTRODUCTION
From the processor board
Between processor boards on
multiple entrance installation
NOTE: LiftMaster is not responsible for conflicts between the information listed in the above table and the requirements of local building
codes. The information is for suggested use only. Check local building codes before installation.

DIMENSIONS

10.1" (25.5 cm)
1
4
7
*
Power Supply: 16 Vdc 2 .5A
INTRODUCTION

INSTALLATION

INSTALLATION
INSTALLATION
INSTALLATION
DISTANCE
Under 30 feet (9 .1 m)
30 - 75 feet (9 .1 - 22 .9 m)
75 - 150 feet (22 .9 - 45 .7 m)
150 - 250 feet (45 .7 - 76 .2 m)
250 - 500 feet (76 .2 - 152 .4 m)
2 3
6.14" (15.6 cm)
5 6
9
8
0 #
INSTALLATION
WIRE TYPE
2 - Conductor Cable
2 - Conductor Cable
2 - Conductor Cable
12 AWG copper wire,
PVC insulated
or
12 AWG copper wire,
uninsulated
24 AWG twisted
pair telephone wire
24 AWG twisted
pair telephone wire
24 AWG twisted
pair telephone wire
POWER WIRE TABLE
AC POWER WIRE SIZE
5.27" (13.4 cm)
(7.6 cm)
2.8"
(7.1 cm)
2
TEST
TEST
RECOMMENDATIONS
Shielded Only - See Power Wire Table Below
See device specifications for wire size
See device specifications for wire size
TEST
Belden #9912
Belden #8011
Shielded - Belden #9502
TEST
Shielded - Belden #9502
Shielded - Belden #9502
18 AWG
18 AWG
18 AWG
16 AWG
12 AWG
3"
(7.6 cm)
4.2" (10.8 cm)
3"
TEST
SET UP
SET UP
SET UP
SET UP
.312"
1.125"
3"
(7.6 cm)
5.03"
(12.8 cm)
SET UP