Wiring A Gate Operator (Normally Open) And A; Door Strike Lock (Normally Open) - LiftMaster EL1SS Manuel D'installation Et De Configuration

INTRODUCTION
WIRING A GATE OPERATOR (NORMALLY OPEN) & A DOOR STRIKE LOCK
(NORMALLY OPEN)
The door strike can be connected to Relay 1 or Relay 2 . See the Set Up section for information about configuring Relays 1 and 2 . INTRODUCTION
INTRODUCTION
AC or DC
Power
NOTE: For DC power
install a 1N4001 diode
or equivalent.
INTRODUCTION
INSTALLATION
INSTALLATION
INSTALLATION
Door Strike
NOTE: Do not use
the unit's power supply
for the door strike.
NOTE: For AC power install a
Siemens S10K30 MOV
(Metal Oxide Varistor) or equivalent.
COM (Common)
NO (Normally Open)
INSTALLATION
TEST
TEST
TEST
COM
(Common)
TEST
8
SET UP
SET UP
SET UP
• Wire connectors can be
removed to simplify wiring .
• DO NOT overload wire
connectors . Use ONLY one
wire per hole .
Primary Gate Operator
(Strike Open Input)
NO
(Normally Open)
SET UP