Wiring A Gate Operator (Normally Open); Wiring An Auto-Call Sensor - LiftMaster EL1SS Manuel D'installation Et De Configuration

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INTRODUCTION

WIRING A GATE OPERATOR (NORMALLY OPEN)

The gate operator can be connected to Relay 1 or Relay 2 . See the Set Up section for information about configuring Relays 1 and 2 .
INTRODUCTION
INTRODUCTION

WIRING AN AUTO-CALL SENSOR

The Auto-Call feature will enable the unit to contact the resident when a driveway sensor (or any device that provides a contact closure)
is activated .
INTRODUCTION
INSTALLATION
INSTALLATION
INSTALLATION
COM
(Common)
NO
INSTALLATION
(Normally Open)
TEST
TEST
• Wire connectors can be removed to simplify
wiring .
• DO NOT overload wire connectors . Use
ONLY one wire per hole .
TEST
NO
(Normally Open)
TEST
7
SET UP
SET UP
SET UP
Primary Gate
Operator
(Strike Open Input)
Loop
Detector
SET UP
Loop Sensor

Publicité

Table des Matières
loading

Table des Matières