John Bean T 7700 Manuel D'utilisation page 50

1
11
50
2
1
4.1-9
4.1-2
2 3
4.1-4
4.1-10
12
4.1-11
Specifi cations
(if present)
Bead presser
The bead presser tool (1, Fig.4.1-9) fi tted on the
articulated arm has a pneumatic control (2, Fig.4.1-9)
for vertical movement.
- Lever up; the bead presser moves up.
- Lever down; the bead presser moves down.
W A R N I N G : T H E O P E R AT I O N S C O U L D
B E D A N G E R O U S . F O L L O W T H E S A F E T Y
INSTRUCTIONS INDICATED ON THE APPLIED
PLATES
Figure 4.1.-2
HAND CRUSHING HAZARD
Wheel lifter (only for version featuring this
device).
- Insert the RIGHT foot under the pedal (1, Fig.4.1-4)
and pull up; the lifter will move up. Once the desired
height is reached, release the pedal to stop the lifter.
- Press the pedal down to make the lifter move down.
- Release the pedal to stop the lifter. To move the lifter
down completely, keep the pedal pressed until the lifter
reaches the ground.
It is forbidden to use the lifter for purposes other than
loading/unloading wheels (or rims) from the Turntable.
The lifter has a maximum capacity of 70Kg/154lb.
DO NOT MOUNT AND DEMOUNT THE TYRE WITH
THE LIFTER UP.
WA R N I N G : T H E O P E R AT I O N S C O U L D B E
DANGEROUS. FOLLOW THE SAFETY INSTRUCTIONS
INDICATED ON THE APPLIED PLATES
Figure 4.1.-10
DANGER OF FEET CRUSHING
Lower bead breaker viewer
(only for version featuring this device)
Monitor (11, Fig. 4.1-11): it facilitates the vision of the
lower bead breaker movement.
Pressure gauge
Pressure gauge (12, Fig. 4.1-11): it indicates the tyre
pressure.
....... .......
-