HQ Power VDPDMXC146 Mode D'emploi page 7

9) Inserting or Adding a Step to a Programme
• Press MODE SELECT to select 1-24 SINGLE / PRESET PARK. The green LED indicator
lights.
• Use the PAGE button to select the page (1 – 4) where the scene is to be added or inserted.
• Slide both master faders (MASTER A = 0 and MASTER B = 10) to the lowest position, place
the FADE slider in the highest position and the SPEED slider in the lowest position (SHOW
MODE).
• The channel fader of the step to be inserted should be slid upwards.
• Press RECORD
• Select CHASE/SCENES (red LED indicator is lit) with the MODE SELECT button
• Hold the EDIT button
• Press the flash button of the scene that has to be inserted in that step.
• Release the EDIT button (the yellow LED indicator of the selected scene is lit)
• Press the STEP button until you reach the scene that will immediately follow the scene to
be inserted
• Press INSERT to add the scene to that programme step.
• Hold the RECORD button
• Press the REC EXIT button
• Release both buttons to leave the programming mode
10) Selecting and Running a Programme
• Press MODE SELECT until the green LED indicator marked '1-24 SINGLE / PRESET PARK'
is lit.
• Select the desired page (1 – 4) with the PAGE button
• Slide the MASTER faders to the highest position
• Move the channel slider for the scene in question to the lowest and then the highest position
to select and run the programme stored under that fader.
11) Running a Programme with TAP SYNC rhythm control
• Make sure the music control function is not active (press the AUDIO button to extinguish the
AUDIO LED indicator if necessary).
• Press the PARK button to select MIX CHASE. The yellow LED indicator is lit
• Select the programme you want to run
• Adjust the speed slider and press TAP SYNC twice to define the beat time
• Hold REC SPEED.
• Press the appropriate flash button under PRESET B to store the new settings
12) Running a Programme with the Speed Slider
• Make sure the music control function is not active (press the AUDIO to extinguish the AUDIO
LED indicator if necessary).
• Press the PARK button to select MIX CHASE. The yellow LED indicator is lit
• Select the programme you want to run
• Move the speed slider all the way down to SHOW MODE
• Hold REC SPEED.
• Press the appropriate flash button under PRESET B to store the new settings
The programme is now controlled through the real-time movement of the SPEED control.
VDPDMXC146 7 VELLEMAN