Control Equipment And Commands For Gas Burners Lme 22 - baltur TBG 85 P-V Manuel D'instructions Pour L'utilisation

IONISATION CURRENT MEASUREMENT
To measure the ionisation current, remove the jumper between
terminals 30-31 on the printed circuit board with the burner off.
specific wiring diagram. After making the measurement, reset the
jumper that has been disconnected.

CONTROL EQUIPMENT AND COMMANDS FOR GAS BURNERS LME 22...

Equipment and Safety
programmer time
LME 22.331A2 3
LME 22.233A2 3
Preventilation Pre-
time ignition
30 2
30 2
0006081468_201610
Time between opening
Post-ignition of 1st flame valve
and 2nd flame valve
2 11
2 11
22 / 28
Air shutter Air shutter
opening closing
stroke time stroke time
12 12
30 30