Electrical Characteristics; Safety Devices - EdilKamin LOGO Installation, Usage Et Maintenance

Masquer les pouces Voir aussi pour LOGO:

Table des Matières

Les langues disponibles

Nominal power

Efﬁ ciency nominal power

Emissions CO (13% O2) nominal power

Smoke mass nominal power

Reduced power

Efﬁ ciency reduced power

Emissions CO (13% O2) reduced power

Smoke mass reduced power

Maximum overheated smoke

Minimum draught

Autonomy (min/max)

Fuel consumption (min/max)

Hopper capacity

Heatable volume *

Weight including packaging

Smoke outlet pipe diameter (male)

Air intake pipe diameter (male)

* The heatable room dimensions are calculated on the basis home insulation in compliance with Italian law 10/91, and subsequent

changes together with an expected heat output of 33 Kcal/m³ per hour.

* It is also important to consider the position of the stove in the room to be heated.

N.B.

1) keep in mind that external devices can cause interference to the operation of the circuit board.

2) caution: live parts. Servicing and/or inspections must be carried out by qualiﬁ ed staff.

Power supply

On/off switch

Average power consumption

Power consumption during ignition

Remote control frequency (optional)

Protection on mains power supply* (see page 23)

Protection on electronic circuit board

The data shown above is purely indicative.

EDILKAMIN s.p.a. reserves the right to change the products at its discretion without notice.

SAFETY DEVICES

• THERMOCOUPLE:

Placed at the smoke outlet to detect the temperature.

Turns the stove on and off and controls its operation based on deﬁ ned parameters.

• AIR FLOW SENSOR:

located in the suction channel, it is activated when the combustion air ﬂ ow is not correct, with consequent pressure problems in

the smoke circuit causing the stove to shut-down.

• SAFETY THERMOSTAT:

Trips when the temperature inside the stove is too high. It stops pellet loading, causing the stove to go out.

CHARACTERISTICS

THERMOTECHNICAL CHARACTERISTICS