Test Procedures; Instructing The Operator - John Bean B600 Manuel D'utilisation

M4x8 (4x)
1
2
3
134
iii-4
iii-5
4
iii-6
iii-7
Installation
Fitting and connecting the monitor
Fig. iii-4 VESA support
The 4 screws needed (M4x8) to fix the VESA support
to the monitor are part of the kit supplied.
 Fix the VESA support to the monitor.
Figure iii-5 monitor power Supply
 Fix the power supply to the back of the machine
using the Velcro strip provided.
Fig. iii-6 Connection of monitor and PC
Caution
Before connecting the electronic cables turn off the
mains switch.
 Insert the monitor connector into the right socket
(2) of the embedded unit.
 Insert the connector USB (3) into the PC and the
monitor.
 Insert the monitor main connector (4) into the
socket.
 Plug in the plug (1, Fig.iii-5) of the power supply
cable.
Figure iii-7 Monitor Cables
 Fix the monitor cables to the supporting pole using
the clips supplied, leaving enough at the top to allow
the monitor to turn freely, as shown.
iv Test procedures
• Balance a wheel to less than 0.25 oz. (5 grams) per
• Balance a wheel to less than 0.25 oz. (5 grams) per
plane.
plane.
• Perform a User Calibration.
v Instructing the operator
(Following applies only if a unit is installed by a service
Technician)
• Show and explain the Safety Booklet.
• Show the operator how to switch the unit on and
off.
• Show the operator how to perform an emergency
stop.
• Show the operator how to select a wheel type, enter
data and apply a weight.

6.2.