John Bean B600 Manuel D'utilisation page 92

92
26
5-63
5-64
5-51
5-65
Operation
Reading of error code E9
If E9 is read out, at least one error was made with
respect to the sequence of operations when performing
Optimization (System messages
 Abort the Optimization program by pressing the
STOP key and, if desired, start Optimization once
again.
Fig. 5-63 Minimization "Un.12"
 Clamp the wheel on the balancer.
 Rotate the wheel such that the valve is exactly
perpendicular to and above the main shaft.
 Confirm the valve position by pressing menu key
26.
The Minimization "Un.13" screen (Fig. 5-64) is
displayed.
Fig. 5-64 Minimization "Un.13"
START is displayed on the screen.
 Spinn the wheel.
A measuring run is performed.
The BALANCING screen (Fig. 5-51) is displayed.
Finish weight Minimization
Fig. 5-51 BALANCING
 Balance the wheel according to the readings.
If the wheel quiet running conditions cannot be
improved on, the following message is displayed:
Fig. 5-65
H0 Wheel running conditions cannot be improved by
Optimization.

7.1).