Installing The Pc-Dialer Iii; Connect The Pc-Dialer Iii To The Isdn (S-Bus); Connect Pc-Dialer Iii To The Telephone; Connect Pc-Dialer Iii To Pc - Swisscom PC-Dialer III Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installing the PC-Dialer III

Once the PC-Dialer III is installed, you can continue to use your telephone in the normal manner
even when your PC is switched off.

Connect the PC-Dialer III to the ISDN (S-bus)

Pull out the S cable on your telephone and connect it to the socket on the PC-Dialer III abelled
"S-bus".

Connect PC-Dialer III to the telephone

Connect your telephone and the socket on the PC-Dialer III labelled "Telephone" using the
enclosed (thicker, 8-pin) cable.

Connect PC-Dialer III to PC

Connect the 9-pin plug to a serial interface (V.24 / RS-232) on your computer.
Depending on the model, you may need to install a modem adapter (from 9 to 25 pin). Such
adapters are available from your local dealer.
Attention:
Make sure the supplied 8-pin cable is inserted in the correct position (see below).
4-pin cable
8-pin cable
41

Publicité

Table des Matières
loading

Table des Matières