Canon imageRUNNER 2422 Guide De L'utilisateur page 50

Computer with
100Base-TX Port
Hub
The RJ-45 Port is located on the
back side of the machine.
IMPORTANT
You cannot use the machine as a repeater, bridge, or gateway.
NOTE
•
The machine can automatically detect the Ethernet speed (10Base-T or 100Base-TX).
•
If you are using a mixed 10Base-T/100Base-TX environment, devices on the network
(hubs, routers, etc.) must support the mixed environment. For more information, consult
your local authorized Canon dealer.
•
After connecting the network cable, perform the following operations. (For more
information, see the relevant descriptions.)
- Set the System Management Settings. (See Chapter 4, "System Manager Settings," in
the Reference Guide.)
- Set the network settings. (See the Network Guide.)
- Install the printer driver if necessary. (See "Before Using the machine as a printer," on
p. 1-22.)
Computer with
10Base-T Port
LAN Cable
Setting Up the Connection
1
1-21