Components; Correct Use - Meister MWS2400-230 Traduction Du Manuel D'utilisation Original

5455320-Winkelschl_man 08.05.15 13:49 Seite 51
use of the machine may deviate from the
specification given in the operating
instructions or determined by the
manufacturer. This may be caused by the
following influencing factors that should
be taken into account prior to and during
each use:
• Is the device being used correctly
• Is the correct type of material being
processed
• Is the device in proper working order
• Are the handles or optional vibration
handles mounted and fixed securely
up against the body of the machine.
If your hands experience an unpleasant
sensation or the skin changes colour
whilst you are using the machine, stop
using the machine immediately. Take
sufficient breaks. If you do not take
sufficient breaks, this may lead to a
hand/arm vibration syndrome.
An estimate of the level of load in
conjunction with the work or use of the
machine should be carried out and
breaks set out accordingly. This method
can be used to considerably minimise the
level of load during the entire working
time. Minimise risks in which you are
exposed to vibrations. Take care of your
machinery in accordance with the
directions in the operation instructions.
If the machine is to be used frequently,
contact your dealer and arrange anti-
vibration equipment (handles) if necessary.
Avoid using the tool in temperatures of
t = 10 °C or lower. Draw up a working
schedule which can be used to
minimise vibration loads.
Information about minimising noise
• A certain amount of noise is
unavoidable when using this device.
Ensure you carry out noise-intensive
work during permitted times.
• Maintain the quiet periods and limit
your work to the absolute minimum.
For the sake of your personal
protection and the protection of
persons in close proximity, suitable
ear defenders should be worn.
3 – Components
1 Control LED
2 Handle
3 On/Off switch mechanism
4 Cover
5 Disc cover for separating discs
6 Spindle with connection thread
7 Screw
8 Spindle lock button
9 Tensioning disc
10 Clamping nut
11 Toroidal coil (Figure 2)
12 Additional handle
13 Flange key
14 Hexagonal wrench
15 Disc cover for roughing discs
4 – Correct use
Use in accordance with the intended
purpose
An angle grinder is an electrically driven
hand-held device with a fast rotating
round grinding disc that is operated via
an angled drive.
Used as a grinder with the appropriate
grinding disc and protective hood, it is
possible to remove flash and to carry out
finishing work on materials of various
steel qualities, bronze and aluminium.
When used as a separator with the
appropriate separating disc and
51