Meister MWS2400-230 Traduction Du Manuel D'utilisation Original page 57

5455320-Winkelschl_man 08.05.15 13:49 Seite 57
d Be especially careful around
corners, sharp edges etc. Prevent
insert tools from bouncing off the
workpiece and becoming jammed.
The rotating tool insert tends to
become jammed at corners, sharp
edges or when it bounces. This will
lead to a loss of control or kickback.
e Do not use a chain or toothed saw
blade. Such tools often cause kick
back or the loss of control of the
electrical tool.
Particular safety notes with regard to
sanding and abrasive cutting:
a Use only grinding tools expressly
permitted for use with your
electrical tool and the appropriate
protective hood for these grinding
tools. Grinding tools which are not
designed for use with the electrical
tool cannot be properly shielded and
are unsafe.
b The safety guard must be attached
securely to the power tool and
adjusted for maximum safety so that
as little of the grinding tool is visible
to the operator as possible. The
safety guard helps protect the operator
from fragments, accidental contact
with the grinding tool and sparks,
which can ignite clothing.
c Grinding tools may only be used for
the recommended applications. For
example: Never sand using the side
surface of a cutting wheel. Cutting
wheels are designed to remove
material with the edge of the disc.
Lateral forces working on these
grinding tools may break them.
d Always use undamaged tensioning
flanges in the correct size and shape
for the sanding disc you have
selected. Suitable flanges support the
sanding disc and thus reduce the
danger of the disc breaking. Flanges
for cutting wheels may differ from
flanges for other sanding discs.
e Do not use worn sanding discs from
larger electrical tools. Sanding discs
for larger electrical tools are not
designed to handle the higher
revolutions of smaller tools and may
break.
f Offset grinding discs must be
installed so that their surface does
not extend beyond the level of the
edge of the safety guard. Improperly
mounted grinding discs which extend
beyond the level of the edge of the
safety guard are not sufficiently
shielded.
Additional safety notes with regard to
abrasive cutting:
a Avoid blocking the cutting wheel or
employing too great a pressure. Do
not execute any excessively deep
cuts. Overloading the cutting wheel
increases the wear and the tendency to
tilt or block and thus the possibility of
kick back or breaking of the grinding
tool.
b Avoid the area in front and behind
the rotating cutting wheel. If you
move the cutting wheel away from
you within the tool, in the event of the
electrical tool kicking back, the
turning wheel may be thrown in your
direction.
c If the cutting wheel blocks or you
stop working, switch the unit off
and hold it still until the wheel has
come to a standstill. Never attempt
to pull a running cutting wheel out
of the cut, this may cause kick
57