Reading The Display - Zodiac Nature2 Fusion Soft Manuel D'installation Et De Fonctionnement

Page 30
ENGLISH
Operating User Interface Controls when
AquaLink RS Control System is Online
®
The user interface can be used
Chlorine
Production
to adjust the output production
Rate
rate (%) when the saltwater
Adjustment
chlorinator system is controlled
with
by the AquaLink RS only when
AquaLink
the AquaLink RS is placed into
RS Online
service mode. When the down arrow
button A or the up arrow button
B is pressed, a JA in the display
indicates that the AquaLink RS
is controlling the entire system,
including the output production
rates.
The AquaLink RS Control System
must be set to Service Mode
before you can change the chlorine
production rate from the control/
power center user interface.
NOTE The Boost button at the
AquaLink Press the Mode Select button to
RS Control move the AquaLink RS from Auto
System Mode into Service Mode. The
Service indicator light will turn ON.
Press the Valve Select button to
choose either Pool Mode to change
pool chlorine production, or Spa
Mode to change spa chlorine
production.
Press the Filter Pump button to turn
on the pump and apply power to the
sanitizing system.
Control/ Press the down arrow button A or
Power the up arrow button B to change
Center the chlorine production rate in 5%
User increments. Generally, adjustments
Interface to production should be made in
10% increments.
AquaLink Press the Mode Select button to put
RS Control the AquaLink RS in the Time Out
System mode.
Press the Mode Select button again
to place it back into Auto mode.
Zodiac Nature
®
user interface will start
Boost cycle whether the
AquaLink RS is online or
offline.
|
Fusion Soft Installation and Operation Manual
2®
NOTE The AquaLink RS control system must be
in pool mode to change the pool chlorine
production rate setting; and it must be in spa
mode to change the spa chlorine production
rate setting. Use the valve select button to
switch between the two (2) modes. The system
must be cycled through SERVICE, TIME OUT,
then back to AUTO to accept the Pool Setting
versus the Spa Setting.
5.2

Reading the Display

CELL ON The CELL ON indicator shows that
CELL
RESTING
FLOW or
NO FLOW
Indication
CELL
REVERSING
the cell has been turned on. Some
reasons for the CELL ON indicator
not being on during normal operation,
are: CHLORINE PRODUCTION
RATE set to 00%, CHLORINE
PRODUCTION RATE set to less
than 100% and CELL RESTING
appears during cell rest period,
NO FLOW condition, two (2)minutes
before automatic cleaning cycle, low
temperature cut off has been activated,
or a service related problem such as a
salinity level below 2.0 gpl or salinity
level too high.
During the normal chlorine production
cycle when the unit is set for less than
100%, the cell will periodically rest;
that is, the unit will not make chlorine.
The CELL RESTING indicator shows
that the cell has been turned off by the
control power center.
When the control/power center
determines that water is flowing past the
flow/temp/salinity sensor, the FLOW
indicator is displayed. When no flow is
detected, NO FLOW is displayed on
the LCD and the cell is turned off.
The automatic cleaning cycle is
in progress. The cleaning cycle is
factory set and cannot be adjusted.
Cell Reversing does not interrupt the
production of chlorine.