Installation Of The Vessel; Figure 2. Anchor Bracket Installation; Figure 3. Pipe Cutout - Zodiac Nature2 Fusion Soft Manuel D'installation Et De Fonctionnement

Page 12
ENGLISH
Install the anchor brackets on
each side foot of the vessel
Figure 2. Anchor Bracket Installation
3.4

Installation of the Vessel

1. Make sure the pool pump is turned off.
2. Install the Nature 2 cartridge.
3. Locate a suitable section of pipe to install the
vessel, approximately 43 cm (17") long, that
conforms to the installation requirements outlined
in Section 3.2.
4. Cut out a 35 cm (13
pipe to insert the vessel (see Figure 3).
5. Connect the outlet from the filter or heater to the
vessel inlet port with the appropriate Schedule 40
PVC pipe; secure the connection with a pipe glue
that is compatible with PVC.
Flow
Outlet
Figure 3. Pipe Cutout
Zodiac Nature
®
/ ") section of the 5 cm (2")
7
8
A
Flow/Temperature/
Salinity Sensor
|
Fusion Soft Installation and Operation Manual
2®
NOTE Reducer bushings can be used to
accommodate 3.8 cm (1.5") plumbing with no
effect on the operation of the Nature
Soft.
6. Connect the vessel outlet port to the pool return
line with the same type of PVC pipe and secure
the connection with pipe glue. Allow sufficient
time for the glue to dry.
7. Hand tighten all unions, sensors, and collars.
Be careful not to get a finger caught between inlet
union and plug when tightening as this may cause an
injury.
8. Start the pump and check for leaks.
Universal Unions and Nuts
for Inlet and Outlet ports
Inlet
A
Flow
")
For a 5 cm (2
with the full unions.
NOTE Total length of the Nature
with the full unions is 42 cm (16⅝
5.7 cm X 0.6 cm (2¼" X ¼")
Stainless Steel Tapcon
Screws and Stainless
Steel Washers
9 cm (3 1/2")
Thick (Min)
Concrete Pad
CAUTION
pipe, the cutout is 35 cm (13⅞
Fusion Soft vessel
2
")
.
Fusion
2
")