Setting The Horizontal Circle Display; Measuring Using The Vertical Circle; Indication Of Inclination; Settings - Hilti POT 10 Mode D'emploi

On the display, this is indicated by the letter R (for right) or the letter L (for left) which appears below the letter H.
When the tool is switched on, the direction of measurement is set as standard to right (clockwise).

8.1.3 Setting the horizontal circle display

en
The reading from the horizontal circle can be held by pressing the HOLD button, the tool then aimed at the new target
and the reading from the horizontal circle released by pressing the button again.
NOTE
On the display, the letter H and, below this, the letters RL blink while the circle reading is held.

8.2 Measuring using the vertical circle

8.2.1 Indication of inclination

Readings from the vertical circle can be shown in the display in degrees or in percent (%).
NOTE
Readings can be shown in % only for this function.
This allows inclinations to be measured in % or objects aligned accordingly.
Measurement of inclinations in % is possible only within the ± 100% range, i.e. ± 45°.
No measurements are possible above or below this range - no value will be displayed.
Press the V% button to switch between degrees and percent % for readings from the vertical circle.

9 Settings

9.1 Displaying the settings menu

To access the settings menu, the tool must be switched off.
34