Setting The Audible Angle Indicator For Each Quadrant; Angle Units - Hilti POT 10 Mode D'emploi

Press and hold the Hold button and the 0-Set button simultaneously.
Then also press the "on" button and keep it pressed until all segments are visible in the display.
Release the Hold and 0-Set buttons after four beeps are heard.
The tool is then in the mode in which settings can be made.
Press the Hold button to switch between various settings.
Press the 0-Set button to switch between the various settings parameters.
Press the V% to confirm and save the settings and to leave the settings mode.
The tool is then in normal operating (measuring) mode.

9.2 Setting the audible angle indicator for each quadrant

There is an audible indicator for each quadrant or, respectively, every 90°/100Gon
Indicator

9.3 Angle units

Changing the angle units for circle readings
ON
Display: 90 bEEP
OFF
Display: NO bEEP
en
35