Setting The Power Level - Hilti TE 70-AVR Mode D'emploi

▶ Set the function selector switch to the "Hammer drilling" position
insert the mixing paddle into the quick-release chuck.

5.5 Setting the power level

TE 70-ATC-AVR
TE 80-ATC-AVR
Power can be set only when the tool is switched on and ready for use.
To set the tool to half power, press the "half power" button. The power
indicator lights up to indicate reduced power. Press the "half power"
button again to switch to full power. The power indicator goes out.
Switching the combihammer off and then on again resets the tool to full
power.
▶ Set the power level.
5.6 Drilling with hammer action (hammer drilling)
▶ Set the function selector switch to the "Hammer drilling" position
5.7 Chisel positioning
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel
positioning". Turn the function selector switch until it engages in the
"Chiseling" position.
The chisel can be set to 24 different positions (in 15° increments). This
ensures that flat chisels and shaped chisels can always be set to the
optimum working position.
▶ Set the function selector switch to the "Chisel positioning" position
5.8 Chiseling 4
▶ Set the function selector switch to the "Chiseling" position
5.9 Control switch lock
When chiseling, the control switch can be locked in the "on" position.
▶ Press the control switch lock.
*2063039*
Printed: 30.08.2019 | Doc-Nr: PUB / 5150793 / 000 / 02
4
2063039
and
4
.
.
English
.
11