Symbols On The Product; Product Information; Declaration Of Conformity - Hilti GX-IE Serie Mode D'emploi Original

1.3 Product-dependent symbols
1.3.1

Symbols on the product

The following symbols are used on the product:
General mandatory sign
Wear eye protection
Wear ear protection
Wear a hard hat
Return waste material for recycling
The power tool supports near-field communication (NFC) technology, which is compatible with
iOS and Android platforms.
Li-Ion battery
Hilti Li-ion battery type series used. Observe the information given in the section headed In-
tended use.
1.3.2 Highlighting of designations and markings
Designations and markings are indicated as follows:
‚ ‛ Description of marked operating controls on the fastening tool
« » Markings on the fastening tool
1.4

Product information

Hilti products are designed for professional users and only trained, authorized personnel are permitted to
operate, service and maintain the products. This personnel must be specifically informed about the possible
hazards. The product and its ancillary equipment can present hazards if used incorrectly by untrained
personnel or if used not in accordance with the intended use.
▶ In the table below, enter the designation and serial number from the type identification plate.
▶ Always quote this information when you contact a Hilti representative or Hilti Service to make an inquiry
about the product.
Product information → page 2
Product information
Fastening tool, gas-actuated
Generation:
Serial number:
1.5

Declaration of conformity

GX-IE
We declare, on our sole responsibility, that the product described here complies with the applicable
directives and standards. A copy of the declaration of conformity can be found at the end of this
documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | D-86916 Kaufering, Germany
2 English
GX-IE
GX-IE XL
01
2208859
*2208859*