Control Screw Tightening And Union Sealing; Engine Oil Level Control - VM Motori D700 Série Manuel D'instructions

Important
In case the engine does not start, try to
restart it without insisting too much in
order not to damage the starter motor.
If the problem persists, contact a techni-

CONTROL SCREW TIGHTENING AND UNION SEALING

Follow the procedure below.
1- Start the engine and run it at minimum
speed for a few minutes.
2 - Run the engine at normal speed until the
operating temperature
reached.
3 - Turn off the engine and let it cool down.

ENGINE OIL LEVEL CONTROL

Follow the procedure below.
1- Start the engine and bring it to the
operating temperature (70÷80 °C).
2 - Turn off the engine and remove
the ignition key.
3 - Place the engine on a perfectly
level surface.
4 - Wait a few minutes so that all
the oil will flow into the sump.
5 - Remove the dipstick (L) and
check the oil level.
6 - Top up, if necessary, from plug
(M). When topping up the oil, to
avoid exceeding the maximum allowed val-
ue, add the oil in small amounts (100 to 200
ml at a time) until it reaches the correct level.
Important
The oil level should be included between
the minimum and maximum marks.
Do not mix oils of different brands or
with different features (See "Recom-
mended lubricants").
English
cal assistance centre that is authorised
by the manufacturer.
11- Stop the motor when you finish this op-
eration.
4 - Make sure the fixing screws of the main
parts are tightened properly.
5 - Check the union sealing on the fuel sup-
ply circuit.
(70÷80°C) is
6 - Check the tightening of the clamps.
7 - Check any fluid leaks.
Dipstick
- 47 -
(L)
(M)
Filler cap
Maintenance information
D700/750 E2-E3
IDM-45300901100.tif
GB